Elcometer 331 Series User Manual

20
S ELECTING BAR SIZE
R
7 SELECTING BAR SIZE
The dimensions of reinforcement bars are stored within the Covermeter. The dimensions are
grouped into four standard series; Metric, Imperial, ASTM/Canadian and Japanese.
To select bar size, display the reading screen and press the BAR softkey to access Bar Size
selection:
• To select bar size, press the SERIES softkey. Use [] or [] to select the appropriate series
(Metric, Imperial, ASTM/Canadian or Japanese). Press [] to accept the bar series and then
use [] or [] to adjust the bar size. Press [] to accept the bar size and return to the Reading
Screen.
The bar sizing functions of the Covermeter will display any measured bar size to the nearest size
in the selected series.
Metric Imperial ASTM/Canadian Japanese
Bar
size
Diam.
(mm)
Bar
size
Diam.
(inch)
Bar
size
Area
(mm
2
)
Bar
size
Diam
(mm)
5 5 #2 0.250 10M 100 6 6
5.5 5.5 #3 0.375 15M 200 10 10
6 6 #4 0.500 20M 300 13 13
7 7 #5 0.625 25M 500 16 16
8 8 #6 0.750 30M 700 19 19
9 9 #7 0.875 35M 1000 22 22
10 10 #8 1.000 45M 1500 25 25
11 11 #9 1.125 55M 2500 29 29
12 12 #10 1.250 32 32
14 14 #11 1.375 35 35
16 16 #12 1.500 38 38
18 18 #13 1.625 41 41
20 20 #14 1.750 44 44
22 22 #15 1.875 48 48
25 25 #16 2.000 51 51
28 28 #18 2.250 57 57
32 32
36 36
40 40
44 44
50 50
331.book Page 20 Thursday, March 12, 2009 9:51 PM

Elcometer 331 Series Specifications

General

Brand	Elcometer
Model	331 Series
Category	Measuring Instruments
Language	English