EasyManua.ls Logo

elddis Autoquest 2021 - Use of the burners; Use of the electric hotplate (if applicable)

elddis Autoquest 2021
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9-6
HOW TO USE YOUR CAMPERVAN’S EQUIPMENT
Use of the burners
Turning on:
Push and turn the control knob.
Turn the control knob anti-clockwise to
the full rate position.
- For spark ignition models: Push the
ignition button.
- For non-ignition models: Hold a lit
match or gas match to the burners.
Keep the control knob pressed for about
10-15 seconds and then release it.
Adjust the height of the flame.
If the burner accidentally extinguishes
turn the control knob to the 0 position and
wait at least 1 minute before re-igniting
the burner.
If the burner has not lit within 15
seconds turn the control knob back to
the 0 position and release it. Wait at
least 1 minute and repeat the steps
above to turn on the appliance.
Turning off:
Turn the control knob clockwise to the 0
position to turn off the burner.
Always make sure the control knob is
in the 0 position when you have
finished using the gas burners.
Do not shut the glass lid when the
burners are lit or still warm.
Use of the electric hotplate (if
applicable)
For the exact location of the control knob,
see Main components.
Turning on:
Rotate the control knob either clockwise
or anti-clockwise to the required position
(1-6).
For maximum efficiency, a correctly sized
pan with a flat heavy gauge base should
be used. The pan size should be the
same or slightly larger than the hotplate
(up to 1”/2.5cm oversize).
Turning off:
Turn the control knob to the 0 position to
turn off the hotplate.
Always make sure the control knob is
in the off position when you have
finished using the hotplate.
Do not shut the glass lid when the
hotplate is turned on or still warm.

Table of Contents

Related product manuals