9-11
HOW TO USE YOUR CARAVAN’S EQUIPMENT
Manual energy selection
To start the refrigerator, press button A for 2
seconds. The LED of the previously selected
operating mode illuminates: 230V, 12V or GAS.
230V, 12V, GAS
Change the operating mode by pressing button A
again. The respective indicator LED will illuminate.
CAUTION: The 230V mains voltage energy
mode should only be selected where the
connected power supply complies with the value
specified on the rating plate. Any difference in
values may result in damage to the appliance!
CAUTION: In order to prevent discharge of
on-board battery, 12V operation should only be
used while the motor is running.
Electronic ignition
1. Press button A several times until indicator
LED (F) illuminates.
2. The ignition process is activated
automatically by means of an automatic
igniter.
Note: The ignition system will make two ignition
attempts with 25 seconds interval when the
burner fails to light. If repeated attempts fail to
start the operation, a fault is indicated (please
refer to failure indication).
CAUTION: Always shut and lock the
refrigerator before you start your journey.
Setting the cooling compartment
temperature
Select the desired cooling compartment
temperature by pressing button B.
The LED display of the selected temperature
setting is illuminated.
The scale starts with MIN in the bottom LED
position (small crystal = highest temperature) and
climbs up to MAX in the upper LED position (big
crystal = lowest temperature).
Note: The temperature levels do not relate to
absolute temperature values.
Note: The cooling unit's performance is
influenced by ambient temperatures. Please select
the medium setting for ambient temperatures
between +15°C and +25°C (refer to Fig 4),
temperature level 3). The unit operates within its
optimum performance range.
Additional features
• The brightness of the display reduces after a
few seconds if no other buttons are pressed.
• If the door is open, the interior lighting is
switched off automatically after two minutes.
• Failures are indicated by flashing of the failure
indicator LED.
• Should the door be kept open for too long
(more than 2 minutes), an acoustic signal is
initiated (pulsing whistle tone).
• Should the electronic control detect any
failure, an acoustic signal will sound (pulsing
whistle tone). At the same time the display
starts flashing (see troubleshooting).
Fig 2
Fig 3
Fig 4
To Next Page
Loading...
