9-15
HOW TO USE YOUR CARAVAN’S EQUIPMENT
TROUBLESHOOTING 1
D = LED failure indicator
G = Temperature setting display
TROUBLESHOOTING 2
Before calling the authorised Service Department please check whether:
l The instructions in the section “Using the refrigerator” have been followed.
l The refrigerator is not tilted excessively.
l It is possible to operate the refrigerator with an available power source.
Failure: The refrigerator does not work on gas.
Possible cause Action you can take
a) Gas bottle empty. a) Change gas bottle.
b) Is the supply cut-out b) Open the cut-out device.
device open?
c) Air in the gas pipe? c) Switch device off and on again 3-4 times to
remove air from the gas pipe.
Status messages on the display
Display Failure
LED is blinking* 230V mode: voltage not available or too low.
LED is blinking* 12V mode: voltage not available or too low.
LED is blinking* GAS/Auto mode: flame not ignited.
All temperature setting LEDs Temperature sensor defective, refrigerator works
are blinking* on mid temperature setting.
LED + temperature level
LEDs are blinking* 230V - Heating element defective.
LED + temperature level
LEDs are blinking* 12V - Heating element defective.
* In case of failure, the "failure" indicator LED illuminates in red.
Continued overleaf
To Next Page
Loading...
