Settings and adjustments
You can change any standard settings of the terminal by the following procedures:
Another short touch of .
END TALK without
access
ACCESS GRANTING
Terminal in stand-by or
during call, talk or monitoring
From stand-by Long press of .
During call, talk or monitoring Short touch of any time.
The access is signaled acoustically also, with a specific confirmation
song and the bidirectional audio communication remains opened
10 more sec.
Short touch of Video and bidirectional talk for max. 10 sec.
* Each short touch of changes the video camera (in case of additional cameras in the system).
VIDEO & AUDIO
MONITORING
Terminal in stand-by
VIDEO IMAGE
ADJUSTMENT
If the image on the display is not ok, you can adjust in this order:
1.Impedance adjustment; 2.Brightness; 3.Chrominance, available on
the terminal's back.
Step 5
Step 3
Step 4
For setting the RINGING VOLUME, short touches of
Each volume level, from 1 to 7, is signaled with increased
intensity of the selected ringtone.
BEEP
The maximum level is signaled with 2 x [ ]. With the
next touch, the volume restarts from level 1.
The last configuration remains set if is not touched
again for 3 sec.
For setting the RINGING DURATION, short touches of :
st BEEP
1 short touch of 1 x [ ] = the terminal will ring once
with the selected ringtone.
nd BEEP
2 short touch of 2 x [ ] = the terminal will ring
twice with the selected ringtone.
rd BEEP
3 short touch of 3 x [ ] = the terminal will ring 3
times with the selected ringtone.
th BEEEEP
4 short touch of 1 x [ ] = the terminal will
ring for 1 min. with the selected ringtone.
The last configuration remains set if is not touched
again for 3 sec.
CALL SETTINGS:
Terminal in stand-by
1. RINGTONE
2. RINGING DURATION
3.RINGING VOLUME
(for both call from
the outdoor panel and
intercommunication)
Step 1
BEEEEP
Simultaneous long press of and [ ].
The terminal goes in setting mode. You have 2 min. to set all
the 3 features, in whatever order you choose. We suggest the
following sequence.
Step 2
For setting the RINGTONE, short touches of :
st
1 short touch of The terminal plays the 1st ringtone.
nd
2 short touch of The terminal plays the 2nd ringtone.
rd
3 short touch of The terminal plays the 3rd ringtone
and so on up to all 5 ringtones available. The last played ringtone
remains set if is not touched again for 3 sec.
Touch the key to quit the setting mode. Or, it will automatically
quit after 7 sec. since the last operation.
44
To Next Page
Loading...
