ElectrIQ iQool9PLUS - Remote Control

OPERATION
7
REMOTE CONTROL
The remote control has a range of up to 8m. Point the remote control at the
receiver in the interior unit. A beep confirms that the remote control signal has
been received.
REMOTE OPERATION
Turn the appliance on using the ON/OFF button. This activates the most
recently used setting.
The ON/OFF button also turns the air conditioner off.
*Horizontal swing not available on most models and the horizontal direction
must be adjusted manually.
BUTTONS
Button
Function
Power
Press to turn the unit on or off.
Turbo
Press to activate turbo mode. This will make the unit work in high performance mode
to quickly cool or heat the room for a period of 15 minutes. The fan will be set to max,
the temperature will be set to either 16
o
C in cooling mode or 31
o
C in heating mode.
Press and hold for 5 seconds to change between Fahrenheit and Celsius.
Mute
Press to reduce the fan speed to produce the lowest possible wind noise.
Mode
Press to change between the different modes.
Eco
Press to turn eco mode on or off.
In cooling mode eco mode slowly increases the desired temperature by 2
o
C. In
heating mode eco mode slowly decreases the desired temperature by 2
o
C
Timer
Press to set the timer.
Press to increase the desired room temperature or adjust the timer duration.
Press to decrease the desired room temperature or adjust the timer duration.
Select the vertical direction of airflow (Model dependant)
Select the horizontal direction of airflow (Model dependant)
Fan
Press to select the fan speed between LOW, MED and HIGH.
Display
Press to turn on/off the LED display.
Sleep
Press to activate the “SLEEP” function
Anti-
Mildew
Press to activate the anti-mildew function. When activated the fan will run for a period
after cooling operation to dry out the indoor unit.
I Feel
Press to activate the follow me function.
Clean
Press to activate the cleaning function.
Health
Press to activate the ioniser function (Not applicable)