ElectrIQ P12C User Manual (English)

Questions and Answers:

D
donna23Jul 31, 2025
Why my ElectrIQ P12C does not seem to perform well?
- D
  Daniel WangJul 31, 2025
  Your ElectrIQ Air Conditioner might not be performing well due to several reasons: * Direct sunlight: Draw the curtains as UV affects the remote control. * Open windows or doors, a large number of people, or a heat source in the room: Close windows and consider using another air conditioner. * Dirty filter: Clean or change the air filter. * Blocked air inlet or outlet: Clear any obstructions. * Room temperature lower than the set temperature: Adjust the setting temperature.
J
Jason MeltonAug 5, 2025
How to fix ElectrIQ P12C Air Conditioner that does not work?
- M
  Mark MedinaAug 5, 2025
  If your ElectrIQ Air Conditioner isn't working, check the following: * Power: Ensure the unit is powered on. * Water-full indicator: Drain the internal water tank. * Timer function: Cancel the timer function. * Room temperature: Use the unit in ambient temperatures between 7-35?
M
Melinda OlsonAug 9, 2025
What to do if the remote control of ElectrIQ P12C doesn’t work?
- A
  Andrea LopezAug 9, 2025
  If the remote control for your ElectrIQ Air Conditioner isn’t working, try these steps: 1. Distance: Move the remote closer to the unit, ensuring it's aimed at the air-outlet grille. 2. Batteries: Replace the batteries in the remote control.
C
Carol RodgersAug 13, 2025
What to do if ElectrIQ P12C compressor does not work?
- J
  Johnny WhitneyAug 13, 2025
  If the compressor in your ElectrIQ Air Conditioner isn't working, it might be due to overheating protection being active. Check the venting and restart the unit after 5 minutes to allow the compressor to cool down.
M
Melinda LunaAug 17, 2025
What does E2/E4 error mean on ElectrIQ P12C?
- C
  Christopher WeaverAug 17, 2025
  If your ElectrIQ Air Conditioner displays an E2/E4 error, it indicates that the water tank inside the machine is full. Drain the water from the drain port located at the bottom rear of the unit.
B
bjacksonAug 22, 2025
What does E3 error mean on ElectrIQ P12C Air Conditioner?
- T
  Terri PatrickAug 22, 2025
  If your ElectrIQ Air Conditioner shows an E3 error, it indicates a pipe temperature sensor failure. Turn off the unit, let it rest for at least 30 minutes, and then restart it. If the error persists, please contact the service center.
J
Julian SanchezAug 26, 2025
What does E0 error mean on ElectrIQ P12C Air Conditioner?
- C
  Christina PetersAug 26, 2025
  If your ElectrIQ Air Conditioner displays error code E0, it means the room temperature is abnormal or there is an electrical short on the temperature sensor. Ensure the temperature is within the 7-35°C operating range. If it is and the error persists, contact the service center to check the room temperature sensor or relevant circuit.