Electro-Voice P3000 - P3000 DETAILED SPECIFICATIONS; Power Supply Specifications; Input Properties and Signal Levels; Output Properties and Voltage Ratings

1
SPECIFICATIONS: P3000 entire unit
Measuring Standard IEC 268 part 3IHF-A
0 dBu = 775 mV (RMS)
A. POWER SUPPLY
1. voltage supply AC
2. nominal supply voltage, depending on the model: 120V/230V/240V
3. nominal mains frequency: 50 - 60 Hz
4. nominal power consumption (2x1200W/4Ω): 4100 W
5. nominal power consumption (2x120W/4Ω): 1500 W
6. power consumption at 1/8 of the nominal power (150W/4Ω): 1650 W
7. deviation range of the power supply: -10 % … +10 %
B. INPUT PROPERTIES
• level control fully open
Input Nominal input level
(nominal source EMK)
select jumper internally
Nominal
output power
Nominal load
impedance
0 dBu +6 dBu +26 dB
Channel A/B +1 dBu +7 dBu +14 dBu 750 W
8 Ω
Channel A/B 0 dBu +6 dBu +13 dBu 1200 W
4 Ω
Channel A/B -2 dBu +4 dBu +11 dBu 1500 W
2 Ω
Channel BRIDGED 0 dBu +6 dBu +13 dBu 2400 W
8 Ω
Channel BRIDGED -2 dBu +4 dBu +11 dBu 3000 W
4 Ω
Maximum input level: +21 dBu
C. OUTPUT PROPERTIES
• nominal output power with THD = 0.1 %, 20 Hz … 20 kHz, MBW = 80 kHz
• maximum output power at 1 kHz with THD = 1 %, MBW = 80 kHz
Output connector Nominal
load
impedance
Nominal output
power Dual
Mode
Maximum output
power Dual Mode,
THD=1 %
Single channel
output
power)
1
Nominal
output
voltage
SPEAKER A/B
8 Ω
750 W 850 W 950 W 77.5 V
SPEAKER A/B
4 Ω
1200 W 1300 W 1700 W 69.3 V
SPEAKER A/B
2 Ω
1500 W 1800 W 2000 W 54.8 V
SPEAKER BRIDGED
8 Ω
2400 W 2600 W 3400 W 138.6 V
)
1
measured with Dynamic Headroom Test-Signal according to IHF-A: 1 kHz Burst, 20ms ON, 480 ms OFF
D. Idling output voltage
Output connector SPEAKER A/B SPEAKER BRIDGED
Max. idling voltage
91 V (RMS) 182 V (RMS)
E. Stabilizing
with nominal load impedance, Dual Mode, standard output voltage
8 Ω 4 Ω
Stabilizing
0.325 % 0.686 %
Stabilizing level
0.028 dB 0.059 dB