50
Food safety
This setting allows to enable / disable ( / ) the following
parameters:
FSC Safety Control (FSC)
The FSC feature guarantee the microbiological safe condition of
the food. If the FSC function is enabled it will be possible to:
• Enable/disable the visualisation of the “F“ factor;
• Enable/disable asking for FSC set on start.
HACCP
• The HACCP feature allows the storage of all the set values
identifying a cooking process, and their variation, the cavity
temperature and, when used, the food core temperature at
specific intervals.
Autostart
This setting allows to enable / disable ( / ) the Autostart in
all modes.
Manual
This setting allows to enable / disable ( / ) the Manual
cooking mode and its options:
NOTE!
If a mode is disabled, it is not visible in the upper
drawer.
General
• Show real and set values. The activation allows to display the
cycle with more detailed information: humidity, temperature
and time are shown as current and set values.
• Always show food probe temperature. It allows to display the
probe temperature values.
• Cooking preheating. It allows the oven to perform the
preheating/precooling phase.
• Advanced preheating. This activation allows to set a temper-
ature to be reached in preheating/precooling phase. Touch
the temperature row and set the required value.
• Delayed start preheating. This activation allows the oven
preparing the cavity for the delayed cooking cycle.
• Multi-phase cooking. It allows the oven to perform Multi-phase
cooking cycle.
Timer/Temperature dialogs
• Short cooking. The activation enables the short cooking
feature showing up.
• Eco-delta cooking. The activation enables the Eco delta
cooking feature showing up.
• Minimum cavity-probe temperature difference. Touch to set
the minimum value on the appearing touchpad (e.g. 5℃).
Touch to test. Hold down to exit.
Food safety
Enable Food Safety Control (FSC)
Enable HACCP
Ask for FSC set on start
Show F value during cooking
SETTINGS
riduzione figura in scala
del 20,5 %
Autostart
Start cooking by closing the door
SETTINGS
Manual
Enable Manual Cooking cycle
General
Timer/Temperature dialogs
Utilities
Hold
SETTINGS
riduzione figura in scala
del 20,5 %
Manual
Enable Manual cooking
Delayed start preheating
Multiphase cooking
General
Always show food
probe temperature
Show real and set values
Cooking preheating
Advanced preheating
SETTINGS
Manual
Enable Manual cooking
5C°
General
Minimum cavity vs probe
temperature difference
Short cooking
Eco-delta cooking
SETTINGS
Timer / Temperature
Utilities
Hold
To Next Page
Loading...
