Electrolux EDW 1003 - Page 33

6.13. Customer function / deactivation of signal sound
When calling the customer function a washing cycle
must not be selected generally!
General information Calling / changing / saving the signal sound deactivation
The function deactivation of the signal sound at the cycle end
Calling the function "signal sound deactivation"
does not exist generally and must be programmed in the
1.
Appliance in switched-off condition
software variant.
2.
Switch on appliance with ON/OFF key S0 -- "prestart" mode
w
The deactivation resp. activation of the signal sound is
Ä
All LEDs of program and option keys are lit.
executed in all designs resp. key arrangements analogously.
w For that you always have to use keys S0
, S1, S2 and S3
3.
Press keys S2 and S3 simultaneously until the
independent of their variant-depending program load.
confirmation LEDs LD1, LD2 and LD3 are flashing.
w
Key S3
is ALWAYS the "signal sound deactivation key"
w The signal sound is always set active by the manufacturer
.
4.
By actuating the function key S3 you now can call the
w
If the signal sound is deactivated, it means that in
function. The confirmation LED LD3 continues
general no acoustic end signal will sound any more.
flashing, LEDs LD1 and LD2 go out.
Even the acoustic fault signals cannot be heard any more! The current condition whether the signal sound is
active or not is signalled by the "END" LED.
"END" LED on = signal sound on
"END" LED off = signal sound off
Deactivation resp. activation of the signal sound
5. / 6.
By any further actuation of the function key S3 you
activate resp. deactivate the signal sound alternating.
Leaving the function
After pressing the function key S1 last you can leave the
special program as follows.
After 60 seconds all LEDs of program and option keys
are lit automatically.
Now the appliance is again in the "prestart" mode
or
the appliance is switched off by ON/OFF key S0
.
Saving the set condition
The currently valid condition is saved directly after
any entry.
EDW 1003 / VGA
LD1 LD2 LD3
S2 S3
ENDE
S0
1.
2.
4.
3.
... AUS nach 60sek. automatisch
LD1 LD2 LD3 LD4 LD5 LD6
S1 S2 S3 S4 S5 S6
LD7
LD8
LD9
LD10
LD11
LD12
S0
S0
LD1 LD2 LD3 LD4 LD5 LD6
S2 S3
blinken
ENDE
LD1 LD2 LD3
S0
LD1 LD2 LD3 LD4 LD5 LD6
S0
... AUS durch manuelle Betätigung über Ein/Aus
LD3
S3
blinkt
5.
ENDE
LD3
S3
blinkt
6.
ENDE
LD3
S3
blinkt
33