28
Oven runners
For easier cleaning you may remove the entire shel-
ving parts from the oven inside.
For this purpose unscrew the knurled nuts, press the
baking sheet guides lightly to the rear, raise and with-
draw forwards from the oven.
Clean the runners in the dishwasher or with a soft
brush in a hot washing–up liquid.
Remove the silicone buffers, clean them sepa-
rately and put them on again.
Refitting: first attach the baking sheet guides at the
rear, then place on the threaded pin at the front and
screw tight with the knurled nut.
Steam generation
system
Water inlet and steam
generator
It is important that the steam generator is rub-
bed dry after every use. Soak the water up
with a sponge and possibly wipe dry with some
drops of vinegar.
In order to reduce limestone deposits only decalcified
water should be used, e.g. from a commercial water fil-
tering device.
Possible limestone residues can be removed with a
mixture of pure water and vinegar.
Caution! Chemical descalers can destroy the
clean–enamel of the oven. Do absolutely fol-
low the specifications by the manufacturer.
1. Pour a mixture of pure water and vinegar (approx.
2 dl) into the steam generator by the water dra-
wer.
2. Let take it effect on the steam generator during ap-
prox. 10 minutes.
The oven interior may be wiped out with the
mixture of pure water and vinegar which is
available in the steam generator as well.
3. Remove the mixture of pure water and vinegar with
a non–scratchy absorbent sponge.
4. Flush the steam generation system with clear and
decalcified water (1–2 dl) by the water drawer.
5. Remove the water with a sponge from the steam
generator and rub dry.
6. In order to dry the steam generator completely
leave the oven door approx. 2 cm open (wedge in
wooden ladle).
To Next Page
Loading...
