Step 1 Turn off the oven and wait until it is
cold.
Step 2 Pull the front of the shelf support
away from the side wall. Hold the rear
of the shelf support and catalytic pan‐
el in place. The catalytic panels are
not attached to the oven walls. They
can fall out when you remove the
shelf supports.
Step 3 Pull the rear end of the shelf support
away from the side wall and remove
it.
Step 4 Install the shelf supports in the oppo‐
site sequence.
The retaining pins on the telescopic
runners must point to the front.
12.4 How to use: Catalytic cleaning
There are catalytic panels in the cavity.
Catalytic panels absorb fat during catalysis.
Spots or discolouration of the catalytic
coating have no effect on the cleaning.
Before the catalytic cleaning
Turn off the oven and wait until it is
cold.
Remove all accessories. Clean the oven floor and the inner
door glass with warm water, soft
cloth and mild detergent.
Clean the oven with catalytic cleaning
Step 1 Step 2 Step 3
Set the function and the oven tem‐
perature: 250 °C
Duration: 1 h
After cleaning, turn the knob for the
oven functions to the off position.
When the oven is cold, clean the
cavity with a wet soft cloth.
12.5 How to use: Aqua Clean
This cleaning procedure uses humidity to
remove remaining fat and food particles from
the oven.
Step 1 Pour water into the cavity embossment:
200 ml.
Step 2
Set the function: .
Step 3 Set the temperature to 90 °C.
Step 4 Let the oven work for 30 min.
Step 5 Turn off the oven.
Step 6 Wait until the oven is cold. Dry the cavi‐
ty with a soft cloth.
18 ENGLISH
To Next Page
Loading...
