Electrolux EWM1100 - Page 15

2007-10 SOI/DT-mdm FCPD-dp Quality-fz 15/59 599 70 32-47
Alarm Possible fault Action/machine status
Reset Page
E54
PCB faulty; current leakage from motor or from wiring.
Cycle blocked, door locked (after 5
attempts).
RESET
41
E61
NTC sensor faulty; heating element faulty; wiring faulty; PCB faulty. The heating phase is skipped.
START/RESET
42
E62
NTC sensor faulty; heating element faulty; wiring faulty; PCB faulty.
Safety drain cycle – Cycle stopped
with door open.
RESET
43
E66
PCB faulty.
Safety drain cycle – Cycle stopped
with door open.
RESET
44
E68
Earth-leakage between heater and earth. Cycle blocked with door open.
RESET
45
E69
Washing heating element interrupted (thermofuse open) ----------------
START/RESET
46
E71
Faulty NTC sensor; Wiring faulty;
PCB faulty.
Heating is skipped.
START/RESET
47
E74
NTC sensor improperly positioned; Faulty NTC sensor; Wiring faulty; PCB faulty. Heating is skipped.
START/RESET
48
E82
PCB faulty (Wrong configuration data). Selector, wiring ----------------
RESET
49
E83
PCB faulty (Wrong configuration data). Selector, wiring Cycle cancelled.
START/RESET
50
E93
Incorrect configuration data; PCB faulty. Cycle interrupted.
OFF/ON
51
E94
Incorrect configuration data; PCB faulty. Cycle interrupted.
OFF/ON
51
E97
Faulty PCB (Wrong configuration data). Cycle interrupted.
RESET
51
EA1
Wiring faulty; Circuit board faulty; DSP sensor faulty; Motor drive belt broken. Drum positioning phase skipped. ON/OFF RESET
52
EA6
Basket cover open. Motor faulty; Wiring faulty; PCB faulty. Cycle interrupted.
ON/OFF RESET
53
EH1
Power supply problems (incorrect / disturbance); PCB faulty.
Wait for frequency nominal
conditions.
OFF/ON
54
EH2
Power supply problems (incorrect / disturbance); PCB faulty. Wait for voltage nominal conditions.
OFF/ON
54
EH3
Power supply problems (incorrect / disturbance); PCB faulty. Wait for voltage nominal conditions.
OFF/ON
54
EF1
Drain tube blocked/kinked/too high;
Drain filter dirty/blocked.
Warning displayed at the end of cycle
(specific LED).
START/RESET
55
EF2
Excessive detergent dosing; drain tube kinked/blocked;
Drain filter dirty/blocked.
Warning displayed after 5 attempts or
by the specific LED.
RESET
55
EF3
Water leaks onto base frame; water control system defective. Machine drains and cycle stops
RESET
55
EF5
Load too unbalanced; final spin phases skipped.
---------------- START/RESET
55
E00
---------------- ---------------- ----------------