7
HEATER
The heating element used in the dishwasher is
mounted to the bottom of the tub with two stainless
steel mounting brackets. The purpose of the heater
is to improve drying, and maintain the water tem-
perature thoughout the complete wash cycle. This
heater can also be used to increase the water
temperature if the high temp options are selected.
The heater used is a PTC design element. This
element allows the wattage to vary depending on the
task it is to perform. When water is to be heated the
wattage draw of the heater will be approximately 900
watts. If the element is used in the dry cycle, the
DRAIN PUMP
Both wash systems use a separate drain pump;
however the mounting and location of the drain
pumps are different. The drain pump for the Preci-
sion Wash system is mounted to the underside of
the tub to the right of the sump. Water enters the
front of the drain pump by a short connecting hose
from rear section of the sump. On the Precision
Direct system, the drain pump is mounted directly to
the front of the sump. Water enters the front of this
pump by a short connecting hose to the rear of the
sump area. Both pumps are dual directional so it
can run either clockwise or counter clockwise. The
front cover of either pump can be removed if needed
for cleaning.
DRYING SYSTEM
Drying dishes in these models is accomplished with a
basic convection dry system. A vent housing
mounted to the top left side of the inner door panel
has a fixed baffle that reduce the sounds from
washing and prevents water from being sprayed out
while the center spray arm is in operation. This baffle
has a one point mount that allows steam and heat to
be released without obstruction. The housing is
mounted to the inner door panel using three screws.
There is a foam gasket between the housing and
panel that is glued in place to prevent water leaks.
Drain pump and mount for
Precision wash system
Drain pump mounted to the sump on
the Precision direct wash system
Front housing
Connecting
hose
Mount
Mount to sump
Connecting hose
Screws
to remove
front housing
Vent baffle
Gasket
To Next Page
Loading...
