Electrolux „KITE“ Bar graph Variant - 5 Fault Diagnosis; What to Do if

- 12 -
DGS-TDS-N 12.07 U. H. / A. B. © Electrolux 599 531 461 EN
5. Fault diagnosis
5.1 What to do if ...?
Problem Possible cause Remedy
The cooking zone cannot be
switched on or is not
functioning
More than 10 seconds have
passed since the appliance
was switched on
Switch appliance back on
The child safety lock is
activated
Deactivate the child safety
lock (see chapter "child
safety lock")
Numerous sensor panels
were touched simultaneously
Only touch one sensor panel
Automatic deactivation has
been triggered
Remove any objects (pot,
cloth, etc.) from the
operating panel, switch
appliance back on
There is water on the
operating panel or the
operating panel is covered
by fat splashes
Wipe over operating panel
Stop + Go is active Deactivate Stop + Go
Buzzer sounds when
appliance is switched off
The operating panels
completely or partially
covered by objects.
Gegenstände entfernen
There is water on the
operating panel or the
operating panel is covered
by fat splashes
Wipe over operating panel
The residual heat display
does not display anything
The cooking zone has only
been on for a short time and
is therefore not hot yet
Contact customer service of
the cooking zone is hot
The buzzer sounds and the
appliance switches itself on
and off again after 5 sec.; the
buzzer sounds again after 5
sec.
The On/Off sensor panel has
been covered up, e.g. by a
cloth
Do not place any objects on
the operating panel
"-" is illuminated Automatic deactivation has
been triggered
Switch cooking zone off,
switch cooking zone back on
again
"E“ and a number are
displayed
Electronics error Disconnect the appliance
from the mains for a few
minutes (remove the fuse
from the house fuse cabinet).
if "E" isstill displayed after
switching back on, contact
customer service
"?“ is illuminated Automatic deactivation has
been triggered
Switch cooking zone off and
then back on again