Installation manual
19
8 At first power up
When the installation is complete and the power is connected for the first time you will be forced to make the following
settings. When one setting is ready you will automatically enter the next one.
• Select language
• Set time and date
• Activate/deactivate the service alarm
For more information about the following settings please refer to the Programming and configuration manual.
8.1 Select language
Select language from the list on the display.
This will be the language that all display messages, program names etc will be presented in.
8.2 Set time and date
Select YES and press the control knob to get to the menu TIME/DATE.
Activate the SET TIME menu and set the correct time.
Save the settings.
Activate the SET DATE menu and set the correct date. Start by setting the year.
• Set the year. Exit to continue with a long press on the control knob.
• Set the month. Exit to continue with a long press on the control knob.
• Set the day. Exit with a long press on the control knob and then save with a long press on the control knob.
Exit the menu when ready.
9 Function check
May only be carried out by qualified personnel.
A function check must be made when the installation is finished and before the machine can be ready to be used.
Open the manual water valves.
Start a program.
• Check that the drum rotates normally and that there are no unusual noises.
• Check that there are no leaks in water supply/drain connections.
• Check that water passes through the detergent container.
• Check that the door cannot be opened during a program.
Ready to use
If all tests are OK the machine is now ready to be used.
If some of the tests failed, or deficiencies or errors are detected, please contact your local service organisation or
dealer.
To Next Page
Loading...
Need help?
General
