Electrolux WD4130 - Conversion Instructions WD4130

44
Installation
Conversion instructions WD4130
• Cut the power to the machine.
• Dismount the rear cover (A).
• Remove nozzle (B).
• Mount the enclosed nozzle (1).
• Replace/mount air reducing plate according
to table on previous page. All air reducing
plate types are shown.
• Loosen the measuring branch screw (C) 1/4
turn, connect a manometer to the measuring
branch.
• Connect the power and select a programme
with heating.
• Start the machine.
• See nozzle pressure in table on previous page
- set the nozzle pressure on setting screw (D)
under cover screw (E).
• Check that the gas flame burns evenly and
has a bluish colour.
• Mount the cover screw (E).
• Remount the rear cover.
NOTE!
After the conversion has been carried out, the
enclosed sign with the new gas type
printed on it must be affixed to the machine
data plate.
7114
3
7115
4
7112A
5
3
4
8
5
5
5
A
B
C
D,E