UNBOXING & SETUP picture pages 6-7
Please be careful while unboxing the air purifier. The unit has several detachable components which may have come loose in transport, so open the box with care and while
placed on a large flat surface OR the floor.
1. Gently remove the unit (e.g. with top handle when available) and the ancillary components from the main box. Remove the plasc packaging and discard as per safety and
local recycling instructions.
2. If wall mounng:
a. Please review safety instrucons under the GENERAL SAFETY secon before proceeding.
b. Idenfy a spot on the wall where you would like to mount the unit. The spot should be at least 20 cm below eye level when standing fully upright (even lower is ideal &
recommended), for opmal viewing as well as cleanability under the unit. Also ensure that nearest power socket is max 1,5 mts away and that there is a clearing of at least 20
cm between right side (sensor window) of the unit and other nearby surface.
c. Gently place the provided hook flat against the surface of the wall and with a pencil mark the two spots where screws are to be drilled. The hook should be placed such
that the protruding tip (without the holes) is on the top (refer to picture #2).
d. Depending on the wall, please use appropriate drill to make two holes into the wall at the identified marks; and insert any plugs as needed.
e. Depending on the wall, please use appropriate screws for following step. Place the hook flat against the surface of the wall, so that the holes are concentric and the hook
sits parallel to the floor without any inclination, and then tighten the screws till the hook is securely in place and does not move if tugged.
f. Lift the unit and place it onto the hook such that the top of the hook securely fits into the inbuilt grip at the back of the unit.
g. Gently adjust the unit to remove any inclinations, just like a painting. Ensure that the unit sits flat up against the wall.
h. When dismounting the unit, remember to disconnect the power cord from the wall socket first.
3. If placing it on the floor:
a. Take the cylindrical feet and screw them into the unit by rotating clockwise till you hear a click (or get some resistance).
b. Lift the unit and place it next to the power socket to be used.
c. Ensure a clearance of at least 30 cm between front (air inlet) and at least 20 cm between right side (sensor window) of the unit and other surfaces. Also ensure ample free
space above the top (air outlet grill), so the unit can operate at its best in spreading pure air through the room.
d. When wall mounting, please remove the cylindrical feet from the base of the unit for more efficient air distribution.
4. Remove the front panel by gently pulling it away from the unit with both hands.
5. Take out the mesh pre-filter, ultrafine particle filter and VOC carbon filter layers and remove all plastic packaging. Discard as per safety and local recycling instructions.
6. Place the filter layers back into the unit in the same order as originally found (i.e. VOC carbon filter goes in first). While inserting, place take care to hold the filter so that the
RFID tag on the filter is located at the top-right it should be near the senor box hatch.
7. Attach the mesh pre-filter and the front panel back to the unit.
8. Plug the unit’s power cord to the nearest power socket so that the POWER button on the product UI gets illuminated.
9. For best results, operate the unit in an enclosed area with doors & windows closed when feasible.
FIRST & ONGOING USE picture pages 6-7
TURNING ON
10. Tap the POWER button once to turn ON the air purifier
NOTE: At every new run, it will take about 10 seconds for the sensors to calibrate and analyze the air quality before ramping up to the appropriate fan speed. During this
time, the air quality indicator will pulsate slowly in white.
To Next Page
Loading...
Need help?
General
