Electrolux WP4700H - Remove of the Transport Locks Fi Tted

2413 21
7
D1363
B
A
D1676
Notice
Date Page
05201053
INSTALLATION
MANUAL
7. Installation
CAUTION
Before putting the machine into service, it is compulsory to remove
the 4 transport locks fi tted.
Remove of the transport locks fi tted
To do so, remove the side casings, then the
fi xing screws of the transportation bridles
(B), as well as the transportation bridle
screws of the down casings (A).
Keep the transport locks fi tted with their
screws and bolts to be able to assemble
them again in case you would need to lift the
machine.
Nota : Never handling the machine
without the transportation bridles.
Weighing option :
Unscrews the fi xing screws of the
transportation bridles (B).
You must connect the compressed air to go
up the tub assembly and release the bridles;
the machine must not be under voltage.
For this, push on the orange button of the
D1/D2 distribution unit in the electric cabinet.
Remove the bridles and the screws.
Then come down slowly the tub by pushing
on the green button of the D1/D2 distribution
unit. So the assembly must rest on the load
cells.
Reset the weighing equipment when you
start the machine.