Electrolux WT830EAG - Instructions for the User; C1 Starting

12
Our appliances have been studied and optimised to give high performance. This appliance must be used exclusively
for the purpose for which it has been designed, i.e. for washing dishes with water and specific detergents. Any other
use is to be considered improper.
This appliance does not carry out the rinse cycle should there be no supply water; it stops all functions with an error
message “A1” (also see “Warning messages”).
TIPS
• Carry out a couple of cycles without dishes to flush out any industrial grease which has remained in the
tank and piping.
• Avoid washing decorated dishes.
• Do not allow silverware to come into contact with other metals.
• Do not allow food to dry on the dishes.
• Remove large food scraps from the dishes to prevent clogging the filters.
• Pre-wash the dishes by spraying them with cold or lukewarm water, without using any detergent.
• Use automatic dispensers for the detergent.
• If there is no automatic dispenser, pour a non-foaming detergent into the tank when the water has reached
the washing temperature.
CONTROL PANEL
Fig. 12
The temperature shown on the display is that of the boiler if the indicator light “E” is on or of the tank if the light “D” is
on. The tank temperature is displayed during the wash cycle and the boiler temperature during the rinse cycle.
C1 STARTING
• Open the water supply cock.
• Switch on at the mains.
• Switch on the dishwasher by pressing the button
“A”.
• Raise the hood by pressing the open/close button
“C” (Fig. 12), or else the buttons located on the
hood (see buttons “P” - Fig. 1.a and Fig. 1.b). Then
make sure all the internal parts are in their seats.
The indicator light of button “A” (Fig. 12) comes
on,indicating that the dishwasher is powered and that
water is being introduced and heated. The word “FILL”
is shown on the display during the entire filling and
heating stage:
If the hood is opened during this stage the message
"CLOSE" will appear on the display:
C INSTRUCTIONS FOR THE USER
P3
P2P1
A
K
D
J
E
H
F
G
B C
LEGEND:
A = on/off
B = drain/self-cleaning cycle
C = open/close hood
K =display
D = “tank” indicator light
E = “boiler” indicator light
J = automatic wash cycle 1
H = automatic wash cycle 2
F = automatic wash cycle 3
G = manual wash cycle