13
The filling and heating stage has finished when the dis-
play shows the tank temperature:
To display the boiler temperature during heating of the
tank, leave the hood and press the button “J” (Fig. 12).
C2 WASH CYCLES
The wash cycle includes one wash with hot water and
detergent (min 55 °C) and one rinse with hot water and
rinse-aid (min 82 °C).
Table of times
Standard cycle time with supply water at 50 °C.
A device lengthens the cycle time if the water in the
boiler has not reached the minimum temperature for
correct rinsing.
The cycle times and the temperature may be personal-
ised (e.g. increase of the rinse time and temperature).
The cycle times should only be set by a specialised
technician.
C3 OPERATION
The filling and heating stage has finished when the dis-
play shows the tank temperature:
The appliance is then ready for use:
• Raise the hood by pressing one of the open/close
buttons.
• Pour the correct quantity of detergent into the tank
if there are no automatic dispensers.
• Load the dirty dishes on to the rack.
• Lower the hood by pressing one of the open/close
buttons.
• Select the wash cycle. The corresponding indicator
light switches on and the wash cycle starts:
- Cycle I
For lightly soiled dishes press button “J” (Fig. 12), (see
table of times).
- Cycle II (recommended)
For normally dirty dishes press button “H” (Fig. 12),
(see table of times).
- Cycle III
For very dirty dishes press button “F” (Fig. 12), (see
table of times).
- Manual cycle IV
For particularly dirty dishes with dried food residue,
dishes with a special shape or for other specific needs
of the user press button “G” (Fig. 12), which initiates a
continuous wash until the operator selects an auto-
matic cycle.
• Press the current cycle button to stop the cycle run-
ning.
• If the hood is opened during a cycle, the wash cycle
will stop until it is closed again.
• If another cycle is selected while a cycle is running,
the wash stage will continue with the set times for the
last selected cycle.
• When the wash is finished the dishwasher emits a
series of beeps, the hood rises automatically and the
message "END" blinks on the display:
The cleaned dishes can now be removed.
The appliance will not remove burnt food deposits
from dishes. Dishes with burnt-on deposits should
be cleaned mechanically/chemically before putting
them in the dishwasher.
Change the water in the tank at least once a day.
Supplied racks
• Tray rack: WT830EA = 1 piece; WT850EA =
2 pieces.
Fig. 13
I II III IV
WT830EAG / PW1EAG 180" 360" 540" MANUAL
WT850EAG / PW2EAG 180" 360" 540" MANUAL
P2
P3
To Next Page
Loading...
