EasyManua.ls Logo

Elektron MULTIMIG 400puls - User Manual

Elektron MULTIMIG 400puls
20 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ELEKTRON-BREMEN Fabrik für Elektrotechnik GmbH x Postfach 10 59 60 x D - 28059 Bremen
Telefon +49 / (0)421 / 54 90 6-0 x Telefax +49 / (0)421 / 54 90 619 x vertrieb@elektron-bremen.de x www.elektron-bremen.de
Operation Manual
MULTIMIG 400puls

Table of Contents

Questions and Answers

  • D
    Dr. Matthew MillsSep 12, 2025
    What to do if there is no function when the torch button is pressed on my Elektron Welding System?
    • N
      Nicole EstradaSep 12, 2025
      If you're experiencing no function when the torch button is pressed on your Elektron Welding System, it could be because the nut of the torch hose is not tight. Tighten it. Another reason could be no connection of the control cable in the torch hose; check and change if necessary. It's also possible that the unit is overloaded, and thermal protection is in function; allow the unit to cool down at no load.
  • L
    Leon DavisSep 14, 2025
    What causes arc or short circuit between contact tip and gas nozzle on my Elektron Welding System?
    • D
      dbowmanSep 14, 2025
      If you're experiencing an arc or short circuit between the contact tip and gas nozzle on your Elektron Welding System, it's likely due to spatter built up inside the gas nozzle. Remove it with special pliers.
  • T
    Tiffany GraySep 16, 2025
    Why is the arc unstable on my Elektron Welding System?
    • C
      Christopher MacdonaldSep 16, 2025
      If you're experiencing an unstable arc with your Elektron Welding System, it could be due to the wrong diameter of the contact tip or a worn-out contact tip. Change the contact tip.

Summary

Safety Precautions and Machine Overview

UVV Inspections (Accident Prevention Regulations)

Short Instructions for Operation

Preparations Before Operation

Torch Connection Procedure

Step-by-step guide for physically connecting the welding torch to the machine.

Mains Connection

Instructions for connecting the welding machine to the power supply socket.

Wire Spool Insertion

Guide on how to correctly mount and prepare the wire spool for feeding.

Ground Cable Connection

Instructions for connecting the ground cable to the workpiece or welding bench.

Wire Electrode Insertion

Gas Cylinder Connection and Setup

Aluminum Welding Modification

Setting the Machine into Operation

DP 20 Operating Panel Overview

Menu Structure and Navigation

Tiptronic Job Programming

Guide on programming, saving, and managing welding jobs using the Tiptronic function.

Special Functions and Operation Modes

Job Selection and Management

Instructions for selecting, activating, deactivating, reprogramming, and copying welding jobs.

Special Functions: Gas & Pump Test

Manual Mode Operation

Guide on operating the machine independently of pre-set characteristics, setting voltage and speed.

Error Codes and Troubleshooting

Code Lock Function

Care and Maintenance Procedures

Troubleshooting Common Issues

Service Contact Information

Elektron MULTIMIG 400puls Specifications

General IconGeneral
Input Voltage3 x 400 V
Duty Cycle60% at 400A
Weight65 kg
Dimensions950 x 520 x 780 mm
Protection ClassIP21S
Power Supply3-phase
Welding MethodMIG/MAG

Related product manuals