Element ELEFT506 - FCC Notes; Specifications

25
FCC NOTES
SPECIFICATIONS
Panel Size 50 inches diagonally
Display Type LED
Panel Technology TFT
Panel 60 Hz Vs. 120 Hz 60 Hz
Display Resolution 1080P
HDMI & Component Support Up to 1080P
Panel Resolution 1920 x 1080
Aspect Ratio 16:9
Dynamic Contrast Ratio-Panel 3000:1
Brightness(CentreTyp.)Cd/M² 250
ResponseTime(GToG) 8.5 ms
LampLife(Typ.Hours) 30,000 hours
HorizontalViewingAngle(AtCR>20) 178
VerticalViewingAngle(AtCR>20) 178
TV System ATSC/NTSC
Channel Range VHF/UHF
Designandspecicationsaresubjectstochangewithoutpriornotice.
-“Warning:Changesormodicationstothisunitnotexpresslyapprovedbytheparty
responsible for compliance could void the user’s authority to operate the equipment.”
- “NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.”
For customer support: 1-888-338-5666