P220 Stationary Barcode Scanner User Manual 6
1.6 Barcode Recognition
In manual recognition mode, the procedure for scanning barcodes is as follows:
(1) Make sure that the scanner, data cable, data receiving host, and power supply are properly
connected and turned on.
(2) Hold down the trigger to activate the LED light.
(3) Move the scanner and adjust the distance between it and the barcode to find the best
recognizing distance.
(4) When hear the prompt sound, the infrared light goes out and the barcode recognizing
successfully, then the scanner will decode the data to the host.
(5) All set barcodes are saved by power outage.
Note: In the recognizing process, for the same batch of barcodes, the distance between the
scanner and the barcode in a certain range which success rate of the recognition barcode will be
very high and that distance is the best recognizing distance.
1.7 Use the Setting Barcode
Set the parameter to a special barcode whose barcode type is barcode128. When scanning to a
barcode software that matches the setting type of setting, it will automatically enter the settings and
does not send the results on the host. All set barcodes are saved by power outage. (except to restore
factory settings)
1.8 Restore Factory Defaults
Note: Please use the "Restore Factory defaults" feature with caution, and when you scan this
setup barcode, the current parameter settings will be lost and replaced with the factory default values.
Restore Factory defaults
To Next Page
Loading...
Need help?
General
