Element14 mi:node - Page 4

User Manual V3.1
Element14 | element14.com/minode 4
Category
#
Module
Qty
Connector
Type
Description
Connect
Board
1
Connect Board
1
NA
A bridge between the micro:bit and the
mi:node sensor modules
Sensor
Modules
(10)
2
Light Sensor
1
Analog Input
Detects the intensity of light in an
environment
3
Speaker
1
Analog
Output/
PWM
Voice output amplifier
4
Temperature and
Humidity Sensor
1
Analog Input
Senses temperature and humidity
within the environment
5
Sound Sensor
1
Analog Input
Detects the sound strength within an
environment
6
Mini Fan
1
Analog
Output/
PWM
A connector board for the DC Motor and
Orbit Fan
7
Relay
1
Digital Output
A digital switch used to control high-
voltage electrical devices, up to a
maximum of 250V
8
Rotary Angle
1
Analog Input
A switch with a 0 - 300 degree dial used
to control voltage output from 0V to
maximum
9
PIR Motion Sensor
1
Digital Input
Senses motion; usually human
movement within range
10
Switch
1
Digital Input
Used to switch voltage ON/OFF
11
RGB LED
1
Digital Output
A colorful Light Emitting Diode. The
color and brightness can be
programmed.
Accessories
12
Orbit Fan
1
Analog Input
Small handheld fan (Located under the
Connect Board in the box)
13
DC Motor
1
Analog
Output/
PWM
Direct Current (DC) motor used to run
the Orbit Fan using the Mini Fan
connector board. Can be used to run
other small devices as well.
Cables
14
E-Brick Connector
Cable
8
N/A
Double ended cables of two different
lengths used to connect sensor modules
to the Connect Board.
2 x 20cm cable
6 x 10cm cable
15
Micro-USB to USB
2
N/A
Two cables, One for power input to the