Element4 Sirius - Gravel Arrangements and Commissioning

25
INSTALLER INFORMATION
Commissioning the appliance
A soundness test MUST be made before the in-
stalled stove is left with the customer.
Ensure that the re is burning at full rate for a
minimum of 5 minutes to warm the ue.
If there are problems, the ue may require
attention.
The stove will produce an odour and/or smoke
for the rst few hours of use. Please ventilate the
room. Also please note that during this initial burn-
ing period, a grey dust deposit will be formed on
the inside of the window, please clean this before
leaving the appliance with the customer.
Gravel Arrangements / Blackstones /
Brilliants
Ensure that the Grate , is sitting rmly in the base
of the re box, with the long slot in the centre of the
Grate aligning with the centre slots on the Burner
Tube. The Pilot ame must be visible through the
grate and the cut-out in the Pilot Shield.
Scatter evenly the Gravel over the top of the Grate
and Burner. Make sure that some holes of grate
are still visible. Ensure that none of the gravel
enters the pilot enclosure.
The Gravel arrangement is now complete, How-
ever, it is important to check that no stones
have entered the pilot area and the cross
lighting is good before the glass is replaced.
The LPG log arrangement is now complete, How-
ever, it is important to check that the Pilot Flame
is still visible.
No pebbles in pilot area!
25
INSTALLER INFORMATION
Commissioning the appliance
A soundness test MUST be made before the
installed stove is left with the customer.
Ensure that the re is burning at full rate for a
minimum of 5 minutes to warm the ue.
If there are problems, the ue may require
attention.
The stove will produce an odour and/or smoke
for the rst few hours of use. Please ventilate
the room. Also please note that during this initial
burning period, a grey dust deposit will be formed
on the inside of the window, please clean this
before leaving the appliance with the customer.
Gravel Arrangements / Blackstones /
Brilliants
Ensure that the Grate , is sitting rmly in the base
of the re box, with the long slot in the centre of
the Grate aligning with the centre slots on the
Burner Tube. The Pilot ame must be visible
through the
grate and the cut-out in the Pilot Shield.
Scatter evenly the Gravel over the top of the
Grate and Burner. Make sure that some holes
of grate are still visible. Ensure that none of the
gravel enters the pilot enclosure.
The Gravel arrangement is now complete, How-
ever, it is important to check that no stones
have entered the pilot area and the cross
lighting is good before the glass is replaced.
No pebbles in pilot area!