4
ment of the Environment, the Building Standards
(Scotland) (Consolidation) Regulations issued by
the Scottish Development Department.
BS 5440 part 1, BS 5871 part 2 and BS 6891.
In the Republic of Ireland the installation must
also conform to the relevant standards, particu-
larly in regard to ue sizing and ventilation. Refer
to documents IS813, ICP3, IS327 and any other
rules in force.
This appliance must be installed in accordance
with the rules in force and used only in a suf-
ciently ventilated space, and is intended for use
on a gas installation with a governed meter.
Before installation, ensure that the local distribu-
tion conditions (identication of the type of gas
and pressure) and the adjustment of the appliance
are compatible. The technical specication of this
appliance is given on the rear page of this manual.
Do not use the appliance if the glass front door
or panel has been broken, removed or is open.
Positioning the appliance
This appliance has been designed to hang
against a wall. This wall must be made of non-
combustible and heat resistant material.
The plaster of the wall has to be resistant to a high
temperature. Use therefore the plaster materials
especially made for this to prevent discoloring
(min. 100 degrees temperature resistant).
Inlet pipe connection 8mm compression
Chimney requirements Balanced Flue
Flue monitor Permanent Pilot
User control: Variable rotary control inc. integrat-
ed Piezo ignition, Permanent pilot facility, Flame
failure device and Oxygen Depletion Cut-out.
Before installation of these appliances, the area
into which the re is to be tted must be cleared
of all debris (including dust), in particular com-
bustible material.
General Fitting Information
GENERAL INFORMATION
If the appliance is to be tted against a wall with
combustible cladding, the cladding must be re-
moved from the area covered, above and around.
As on all heat producing appliances, soft fur-
nishes such as blown vinyl wallpaper placed too
near to the appliance may become scorched or
discoloured. This should be born in mind when
installing the appliance.
Note:
Since the appliance is a source of heat, circulation
of air occurs. Therefore it is of importance that you
do not use the appliance shortly after a renovation
of the home. Because of the natural circulation
of air, moist and volatile components from paint,
building materials, carpet etc. will
be attracted. These components can settle them-
selves down onto cold surfaces in the form of soot.
Prevention of Rust:
Always switch off the re completely after use.
Do not leave pilot ame on.This saves gas
and prevents corroding of your re.
To Next Page
Loading...