Element4 Sirius - Flame Height, Standby, and Switching Off; Temperature Display and Time Setting; Thermostat Function

7
USER INFORMATION
Flame height / standby
The ame height can be adjusted continuously by
using the buttons and
By continuing to lower the ame height, the ap-
pliance can be set to the standby position; this
means that only the pilot burner will still be burn-
ing.
Press button (small ame) to lower the
ame height and/or to set the appliance in the
standby position.
Press the button (large ame) to raise the
ame height and/or to switch on the main burner
from the standby (pilot burner) position.
Caution - If you continue to press down button
(large ame) on the remote control,
the main burner should be largely ignited
within about 10 seconds. If this is not the
case, you must close the gas tap and warn
your installer;
- If the appliance ignites with a pop sound,
you must close the gas tap and contact your
installer.
Switching off
Switch the appliance off by pressing the OFF
button. The pilot burner will also go out.
Temperature display
The room temperature can be indicated on the
display in degrees Celsius (°C) using a 24 hour
clock or degrees Fahrenheit (°F) using a 12 hour
clock.
Simultaneously press OFF
and (small
ame)
, until the correct display appears.
Time
The display can indicate time.
After placing the battery or simultaneously press-
ing
(large ame) and
(small ame), the time indication will ash on the
display and you will be able
to adjust the time.
Simultaneously press and until the time indication
ashes on the display.
Press the button (large ame)
to set the hours.
Press the button (small ame) to set the
minutes.
Press OFF to return to the MAN position,
or wait for the system to automatically return to
the MAN position.
Thermostat function
Using the thermostat function you can set
two temperatures, which can be controlled
thermostatically. These temperatures are referred
to as day temperature and night temperature.
The
✹
TEMP and TEMP symbols on
the display refer to day and night temperature
respectively.
The room temperature is compared to the set
day/night temperature and then the ame height
is automatically controlled in order to reach the
set temperature.To be able to use the day/night
temperature function, the appliance must be
in the standby position.
!Caution - Always leave the remote control at
the same place, so that the thermostat is
able to ‘feel’ the room temperature;
- Make sure this place is free from inuences
such as draught, heat from radiators
and direct sunlight.