13
3 Security
Elenos products meet the safety standards required for this type of equipment.
3.1 Precautions
However, the user must also observe the precautions listed below:
• Original equipment configuration must not be altered. Upon receipt it you must
check that it correspond to the order and in case of non-compliance you must im-
mediately inform Elenos.
• The protective devices should not be disconnected (except to replace), altered, or
changed without permission.
• Check periodically and after the occurrence of a fault the protection devices (such
devices against overvoltage, overcurrent, breaker circuit, etc...)
• For safety and to ensure the device integrity is absolutely forbidden to put it in fun-
ction and/or to handle it with open doors and/or without protection panels and/or
devoid earth connection, which must be always top quality and in accordance with
standards. It is also forbidden to disconnect and/or to modify the means protection
instruments of equipment.
• Before starting work, the equipment must be isolated from the network. Disconnec-
tor must be verified by inspection.
• The equipment should operate only at expected voltage. Incorrect voltage can cause
irreparable damage to the equipment and operator. That statement is on the label
of the product, usually located in the wrapping. This should not be removed for any
reason, even if the equipment was resold.
• The equipment must be powered by an electrical system that is in compliance with
all standards.
• Pictograms are applied on the equipment, indicating safety precautions that must
be carefully respected by anyone who is about to use it. Failure to comply with the
requirements raises the Manufacturer to be liable for any damage to persons or
thing which may arise and makes the operator himself solely responsible.
Dangerous voltage
Security
To Next Page
Loading...
Need help?
General
