49Use instructions
7.1.14 Alarms Audio Settings
From there you can set these audio alarms:
• alert in case of audio absence
• alert in case of overmodulation.
In the first case should be set to the threshold of sound the time for which it must veri-
fy the condition.
In the second case must be set to the level of overmodulation and the time for which it
must verify the condition.
7.1.15 AES/EBU Settings
If you have AES/EBU connection you can still choose the ANALOG operating mode throu-
gh this screen, setting “Audio input mode” properly as ANALOG or AUTO.
In the first case “Current mode” becomes ANALOG, conversely becomes AES/EBU.
7.1.16 Time Base
From here you can set the VCO synchronization, as internal (TCXO), or external.
It can be set the external reference frequency equal to 10.000 MHz or 12.800 MHz.
When using internal reference, in each case, is equal to 12.800 MHz (not editable).
7.1.17 Profile Summary 1 of 2
It is the first screen which shows the status profiles.
The parameters displayed are: frequency, power, audio, input type, pre-emphasis.
To Next Page
Loading...
Need help?
General
