What to do if the reservoir low level audible alarm sounds on my ELGA Medica EDI 15?
To address a low reservoir level audible alarm on your ELGA Laboratory Equipment, first, press the crossed bell button to mute the alarm. Ensure the reservoir is refilling automatically and that the display icon indicates this. Check the feedwater supply and all connections to the reservoir.
Why is the water purity alarm going off on my ELGA Medica EDI 15?
If your ELGA Laboratory Equipment displays a water purity alarm, verify that the alarm set value is correct. Allow the system to recirculate. If the alarm continues, replace the ion-exchange cartridge. If the problem persists beyond what is expected under normal operating conditions, it may be necessary to contact your local distributor.
How to troubleshoot low output flow in ELGA Medica EDI 15 Laboratory Equipment?
If the output flow of your ELGA Laboratory Equipment is below specification, verify the supply pressure. Note that low water temperature can reduce flow. Ensure the inlet strainer and recirculation strainer are clean. If necessary, contact a service technician to fit or replace the booster pump. Also, a fouled 0.2µm filter may be the cause, so replace the filter if needed.
What should I do if the UV lamp failure audible alarm sounds on my ELGA Laboratory Equipment?
To address a UV lamp failure audible alarm on your ELGA Laboratory Equipment, start by pressing the crossed bell button to mute the alarm. Make sure all electrical connections are secure. When applicable, follow the UV lamp replacement procedure. You can temporarily continue operation without the UV lamp if needed.
Why is my ELGA Medica EDI 15 system noisy?
If your ELGA Laboratory Equipment is making unusual noises, open the front door and secure the pipework to stop any vibration.
General| Brand | ELGA |
|---|---|
| Model | Medica EDI 15 |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
