ELGA Purelab flex 3 Service Manual

Service Manual
PURELAB flex
Introduction Issue 3 Page 1 of 52
Covers the following products:
PURELAB
®
flex 3
PURELAB
®
flex 4
ELGA LabWater assumes that the technician using this manual has a working knowledge of
water purification systems and has attended an ELGA LabWater technical training course.
This manual is correct for use with the PURELAB range of systems mentioned above. For
information on other products from ELGA LabWater please refer to the relevant service
manual available from
www.elgalabnet.net.
If you would like to contact us with regards to training or give us any feedback on this
manual please contact technical support at
techsupport@elgalabwater.com

ELGA Purelab flex 3 Specifications

General

Type	Water Purification System
Model	Purelab flex 3
Feed Water Requirements	Potable water
TOC	< 5 ppb
RNase	< 0.01 ng/mL
Flow Rate	Up to 2 L/min
Resistivity	18.2 MΩ·cm
Bacteria	<1 CFU/mL
Particles	<1 particle/mL > 0.2 μm
Power Supply	100-240 V AC
Operating Temperature	5-35°C
Operating Humidity	<80% relative humidity, non-condensing
Output Water Type	Ultrapure Type I water