Need help?Do you have a question about the ELGA Purelab flex 3 and is the answer not in the manual?
Read Health & Safety notes in Section 9 for safe operation.
Manual covers PURELAB flex 3 (tap water) and PURELAB flex 4 (RO feed).
Guides basic operation and maintenance for meeting requirements.
Quick Start Guide details installation and commissioning procedures.
Unit requires a clean, dry, level surface for installation.
Unit is supplied in a preset mode requiring completion before dispensing.
Contact local ELGA representative for assistance or visit website.
Procedures for replacing the UV lamp when it fails or efficiency drops.
Steps to isolate, dismantle, clean, and reassemble the inlet filter.
Information on replacing the RO module, contact customer support for details.
Details on replacing vent and point-of-use filters are in Quick Reference Guide.
Specifies operating environment: clean dry indoor, temp 5-40°C, humidity max 80%.
Caution that the display handset is not designed to be submerged.
Notes on appliance coupler, power supply, and earthing protection.
Warning about UV lamp exposure causing serious injury; disposal according to regulations.
Warning about residual biostat flushed during commissioning; MSDS available.
MSDS for purification packs are available upon request.
General| Type | Water Purification System |
|---|---|
| Model | Purelab flex 3 |
| Feed Water Requirements | Potable water |
| TOC | < 5 ppb |
| RNase | < 0.01 ng/mL |
| Flow Rate | Up to 2 L/min |
| Resistivity | 18.2 MΩ·cm |
| Bacteria | <1 CFU/mL |
| Particles | <1 particle/mL > 0.2 μm |
| Power Supply | 100-240 V AC |
| Operating Temperature | 5-35°C |
| Operating Humidity | <80% relative humidity, non-condensing |
| Output Water Type | Ultrapure Type I water |
To Next Page
