PURELAB flex 3/4 Operators Manual ELGA
Page 2 PURELAB flex 3/4 MANU39265 Version 01 - 09/10
1. INTRODUCTION
1.1 Health & Safety
Please ensure you read the Health & Safety notes in Section 9.
1.2 Product Range
This Operators Manual has been prepared for PURELAB flex product models:
x PURELAB flex 3 (Ultra Pure Water (Type I) Directly from tap water)
x PURELAB flex 4 (Ultra Pure Water (Type I) from RO (Type III) feed water)
1.3 Use of this Manual
This manual guides you through the basic operation and maintenance of the PURELAB
flex allowing you to obtain a guaranteed supply of purified water to meet your
requirements.
1.4 Installation
PURELAB flex is supplied with a Quick Start Guide and Quick Reference Guide.
Quick Start Guide shows you how to install and commission the PURELAB flex.
Quick Reference Guide shows you how to perform day to day functions in order to get
the most from your PURELAB flex without having to refer to the Operators Manual.
1.5 Environment
The PURELAB flex unit should be installed on a flat, level surface, in a clean, dry
environment. The unit can also be wall mounted using the purpose designed wall
mounting kit against a vertical wall capable of supporting the combined weight of the
unit and mounting kit.
1.6 Commissioning
PURELAB flex is supplied in a preset commissioning mode which has to be completed
before purified water can be dispensed.
1.7 Customer Support
If you need help with your PURELAB flex, please call your local ELGA representative. For
the address of the nearest ELGA LabWater Sales and Service office visit the country list
on our website.
www.elgalabwater.com
Or contact ELGA LabWater at;
E-mail: techsupport@elgalabwater.com
E-mail: info@elgalabwater.com
To Next Page
Loading...
