What to do if the Elma Cleaning Equipment display does not light up?
If the display of your Elma Cleaning Equipment doesn't light up, it could be due to the unit not being switched on or a lack of power. First, ensure the device is switched on. Then, check the power cable to confirm it's correctly connected and undamaged. If damaged, replace the cable. Finally, verify the power supply.
Why is the blower off on my Elmasonic Med 120–900 Cleaning Equipment?
The blower might be off because the ultrasound is off and the bath temperature is below 50 °C. Check the blower if the ultrasound is switched on or the bath temperature is above 50 °C.
What to do if the filling level is too low in Elma Cleaning Equipment?
If the filling level is too low, top up the fluid in your Elma Cleaning Equipment. If the symbol continues to be displayed, have the heating system repaired.
Why is it not possible to set a high bath temperature on my Elma Cleaning Equipment?
The inability to set a high bath temperature on your Elma Cleaning Equipment might be because a low temperature limit has been defined. Check the unit settings and increase or deactivate the temperature limit as needed.
General| Ultrasonic Frequency | 37 kHz |
|---|---|
| Material Tank | Stainless steel |
| Frequency | 37 kHz |
| Material | Stainless steel |
| Operating Mode | Continuous |
Defines the intended audience and their required qualifications.
Lists external documents and regulations relevant to unit operation.
Explains predefined settings and how they can be customized or reset.
Confirms the unit meets EU CE marking requirements.
Specific guidelines for using the unit to clean medical instruments.
Defines improper usage and its consequences on warranty and liability.
Explains the system of signal words and their associated danger levels.
Clarifies the meaning of various warning and information symbols on the unit.
Details the interpretation of symbols found on the unit's identification plate.
Covers risks associated with electrical power, fire, infections, hot surfaces, and cleaning agents.
Specifies the types of cleaning agents suitable for ultrasonic cleaning.
Provides essential safety precautions for handling aggressive, corrosive, or flammable cleaning agents.
Presents the technical specifications for the Elmasonic Med 30-100 model series.
Presents the technical specifications for the Elmasonic Med 120-180 model series.
Presents the technical specifications for the Elmasonic Med 300-900 model series.
Covers electrical, ambient, and sound data for various models.
Explains how the display shows selected ultrasound modes.
Describes the meaning of various symbols indicating the unit's current status.
Details the different operational states: Switched off, Standby, Setup, Normal, and Programme.
Specifies requirements for the environment where the unit will be installed.
Step-by-step instructions for unpacking and positioning the unit.
Guidance on connecting the drain and power supply for operation.
How to set duration, mode, and temperature for operation.
How to select and start pre-saved cleaning programmes.
Safe removal of cleaned items, including hot fluid precautions.
Guides on resolving common operational faults and display errors.
Lists specific fault codes and their possible remedies.
To Next Page
