How to fix Elma Elmasonic Select 60 when the display does not light up?
If the Elma Cleaning Equipment display doesn't light up, first ensure the unit is switched on. Then, check the power cable for proper connection and any damage, replacing it if needed. Finally, verify the power supply.
Why is the blower off on my Elmasonic Select 120–900 Cleaning Equipment?
If the blower is off in your Elmasonic Select 120–900, check if the ultrasound is switched on or if the bath temperature is above 50 °C. If the ultrasound is on or the temperature is higher than specified and the blower is still off, there may be a defect.
What to do if Elma Cleaning Equipment display shows Er?
If your Elma Cleaning Equipment shows 'Er' on the display, check the error code and attempt to rectify the fault.
What to do if Elma Elmasonic Select 60 Cleaning Equipment shows filling level too low?
If the filling level is too low on your Elma Cleaning Equipment, top up the fluid. If the symbol indicating low filling level continues to be displayed after topping up, the heating system may require repair.
What to do if max bath temperature exceeded on Elma Elmasonic Select 60 Cleaning Equipment?
If the maximum permissible bath temperature is exceeded on your Elma Cleaning Equipment, switch off the unit and allow it to cool. Disconnect it from the mains power if necessary.
Specifies the product's intended purpose and general operating guidelines.
Defines misuse and outlines its consequences, including warranty invalidation.
Details safety measures related to electrical connections and operation.
Outlines critical safety steps to prevent fire and explosion hazards.
Provides guidance on hygiene, fluid changes, and avoiding burns from hot components.
Specifies acceptable cleaning agents for ultrasonic cleaning and provides a resource.
Discusses limitations and chemical compounds to avoid when using cleaning agents.
Precautions for using corrosive cleaning agents to prevent chemical burns.
Details risks with combustible agents and relevant GHS pictograms.
Explains how unsuitable agents can cause pitting and damage the stainless-steel tank.
Details the function of each button and display element on the control panel.
Explains the different ultrasound modes and their segment displays on the unit.
Highlights risks like hot liquids, noise emissions, and dry running during operation.
Guides the user through changing unit settings in the Setup menu.
Provides solutions for common operational problems and their possible causes.
Explains error codes and symbols displayed by the unit indicating faults.
Lists additional error messages and their remedies not covered in basic troubleshooting.
General| Ultrasonic Frequency | 37 kHz |
|---|---|
| Material Tank | Stainless Steel |
| Material Casing | Stainless Steel |
| Timer | 1-30 minutes |
| Heating | Yes |
| Temperature Range | 20 - 80 °C |
| Tank Dimensions | 300 x 150 x 150 mm |
| Operating Modes | Sweep, Degas |
To Next Page
