How to fix Elma Elmasonic Select 900 Cleaning Equipment when the display does not light up?
If the Elma Cleaning Equipment display doesn't light up, first ensure the unit is switched on. Then, check the power cable for proper connection and any damage, replacing it if needed. Finally, verify the power supply.
Why is the blower off on my Elmasonic Select 120–900 Cleaning Equipment?
If the blower is off in your Elmasonic Select 120–900, check if the ultrasound is switched on or if the bath temperature is above 50 °C. If the ultrasound is on or the temperature is higher than specified and the blower is still off, there may be a defect.
What to do if Elma Elmasonic Select 900 Cleaning Equipment display shows Er?
If your Elma Cleaning Equipment shows 'Er' on the display, check the error code and attempt to rectify the fault.
What to do if Elma Cleaning Equipment shows filling level too low?
If the filling level is too low on your Elma Cleaning Equipment, top up the fluid. If the symbol indicating low filling level continues to be displayed after topping up, the heating system may require repair.
What to do if max bath temperature exceeded on Elma Elmasonic Select 900?
If the maximum permissible bath temperature is exceeded on your Elma Cleaning Equipment, switch off the unit and allow it to cool. Disconnect it from the mains power if necessary.
Explains the signal words (DANGER, WARNING, CAUTION, NOTICE) and their associated consequences.
Provides safety information related to electrical power, fire/explosion risk, infections, and hot surfaces.
Highlights the risk of fire/explosion with combustible agents and prohibits agents with specific GHS pictograms.
Provides mechanical and performance data for Elmasonic Select models 30, 40, and 60.
Lists mechanical and performance data for Elmasonic Select models 80, 100, and 120.
Presents mechanical and performance data for Elmasonic Select models 150, 180, and 300.
Details mechanical and performance specifications for Elmasonic Select models 500 and 900.
Provides mechanical, electrical, and ambient condition data for Elmasonic Select models 30-900.
Explains the different ultrasound modes (degas, eco, sweep, pulse, dynamic) shown on the display.
Details the symbols that indicate the unit's operating status, such as end of cleaning or heating.
Describes the different operating modes: Switched off, Standby, Setup, Normal mode, and Programme mode.
Provides instructions on how to start ultrasonic cleaning, including display indicators and during-operation adjustments.
Lists common faults, their possible causes, and recommended resolutions.
Explains how to identify and rectify specific fault messages displayed on the unit.
General| Model | Elmasonic Select 900 |
|---|---|
| Tank Capacity | 9 liters |
| Frequency | 37 kHz |
| Material Tank | Stainless Steel |
| Temperature Range | 20-80 °C |
| Operating Modes | Pulse |
| Timer | 1-99 minutes |
To Next Page
