How to fix Elma Elmasonic Select 120 Cleaning Equipment when the display does not light up?
If the Elma Cleaning Equipment display doesn't light up, first ensure the unit is switched on. Then, check the power cable for proper connection and any damage, replacing it if needed. Finally, verify the power supply.
Why is the blower off on my Elmasonic Select 120–900 Cleaning Equipment?
If the blower is off in your Elmasonic Select 120–900, check if the ultrasound is switched on or if the bath temperature is above 50 °C. If the ultrasound is on or the temperature is higher than specified and the blower is still off, there may be a defect.
What to do if Elma Cleaning Equipment display shows Er?
If your Elma Cleaning Equipment shows 'Er' on the display, check the error code and attempt to rectify the fault.
What to do if Elma Elmasonic Select 120 shows filling level too low?
If the filling level is too low on your Elma Cleaning Equipment, top up the fluid. If the symbol indicating low filling level continues to be displayed after topping up, the heating system may require repair.
What to do if max bath temperature exceeded on Elma Elmasonic Select 120 Cleaning Equipment?
If the maximum permissible bath temperature is exceeded on your Elma Cleaning Equipment, switch off the unit and allow it to cool. Disconnect it from the mains power if necessary.
Defines misuse and its consequences, including warranty invalidation.
Details requirements for the unit's installation location.
Instructions for connecting the drain and network cable.
Provides solutions for common unit faults and issues.
Explains error codes and symbols displayed by the unit.
General| Brand | Elma |
|---|---|
| Model | Elmasonic Select 120 |
| Category | Cleaning Equipment |
| Language | English |
To Next Page
