How to fix Elma Elmasonic Select 300 when the display does not light up?
If the Elma Cleaning Equipment display doesn't light up, first ensure the unit is switched on. Then, check the power cable for proper connection and any damage, replacing it if needed. Finally, verify the power supply.
Why is the blower off on my Elmasonic Select 120–900 Cleaning Equipment?
If the blower is off in your Elmasonic Select 120–900, check if the ultrasound is switched on or if the bath temperature is above 50 °C. If the ultrasound is on or the temperature is higher than specified and the blower is still off, there may be a defect.
What to do if Elma Elmasonic Select 300 Cleaning Equipment display shows Er?
If your Elma Cleaning Equipment shows 'Er' on the display, check the error code and attempt to rectify the fault.
What to do if Elma Cleaning Equipment shows filling level too low?
If the filling level is too low on your Elma Cleaning Equipment, top up the fluid. If the symbol indicating low filling level continues to be displayed after topping up, the heating system may require repair.
What to do if max bath temperature exceeded on Elma Cleaning Equipment?
If the maximum permissible bath temperature is exceeded on your Elma Cleaning Equipment, switch off the unit and allow it to cool. Disconnect it from the mains power if necessary.
Defines the intended purpose and lists correct usage guidelines for ultrasonic cleaning.
Defines misuse, its consequences, and provides examples of improper use.
Details safety information related to electrical power, fire, infections, and hot surfaces.
Specifies permissible cleaning agents, focusing on aqueous and ultrasonic-suitable types.
Discusses limitations and considerations when using chemical compounds as cleaning agents.
Provides mechanical and performance data for Elmasonic Select 30-60 models.
Provides mechanical and performance data for Elmasonic Select 80-120 models.
Details requirements for the installation site, including ventilation and surface characteristics.
Details steps for connecting the drain and the network cable.
Outlines the prerequisites and steps for switching the unit on.
Details how to initiate the ultrasonic cleaning process and what to expect on the display.
Provides a table for troubleshooting common faults and their possible causes and resolutions.
Lists specific fault messages, their types, and possible remedies.
General| Model | Elmasonic Select 300 |
|---|---|
| Frequency | 37 kHz |
| Material Tank | Stainless steel |
| Operating Modes | Sweep |
| Temperature Range | 20 to 80 °C |
| Timer | 1-30 min |
To Next Page
