PDF Studio
-
PDF Editor for Mac, Windows, Linux. For Evaluation". https://www.doppa.com/pdfstudio
Threading the Upper Thread
Make
sure
that
the thread take-up lever and the presser
foot
are
in
their
highest positions.
1
(.0
Pull
out
the spool pin and place the spool
of
thread
on
it.
Hold back the spool
with
the tip of
your
finger and pass the
thread through in the following order: (all the thread guides
are
open, including the thread take-up lever)
Top thread guide.
Universal
upper
thread tension, marked betwen 4‘/2 and 5‘/2.
Important
to
ensure
good sewing results:
Give the thread a sharp tug downwards
so
that
it is properly
engaged in the tension device.
4
5
∞∖∣⊚
Check spring (from right
to
left).
Thread take-up lever
—
pass the thread through the
rear
of
the notch in
cover
(from right
to
left). The thread
will
slip
into
the opening
of
the thread take-up lever.
Front thread guide.
Needle clamp.
Needle. It is threaded from the
front
to
the back. (If the
needle threader is used,
it
must
therefore be inserted into the
eye
of
the needle from the back.)
Pull forward about 15
cm
(6'')
of
thread
to
the
front.
PDF Studio - PDF Editor for Mac, Windows, Linux. For Evaluation. https://www.qoppa.com/pdfstudio
To Next Page
Loading...
