Example of a Program Set-up
Safety 4 Thread
Use the recommendations for the
settings found on the reference card.
Elna recommends reading symbols from
left to right.
1. Adjust differential feed dial to 1.
2. Adjust stitch length dial to 2.5.
3. Set cutting width dial to N.
NOTE:
Machine should not be threaded
before program set-up occurs.
Cut and remove all threads.
HINT:
Cut thread at looper and needle eyes
and hand pull thread away.
IMPORTANT:
Never press on foot control to sew
out thread.
IMPORTANT:
Always hand turn flywheel towards
you (counter-clockwise).
26
CW
SL
DF
1
2.5
N
1
2
3
S
To Next Page
Loading...
