69
Twin Needle Sewing
The utility stitches and decorative stitches shown on the
left can be sewn with a twin needle.
Replace the needle with the twin needle supplied with
the standard accessories.
w
z
x
v
c
b
b
Insert the extra spool pin into the hole beside the
horizontal spool pin.
Place a spool of thread on the extra spool pin and x the
spool with the spool holder.
w Extra spool pin
Draw both threads from the spools and pass them
through the threading points from z to b.
Make sure that the two strands of thread from the spools
do not get tangled.
NOTE:
Threading from points z to b is the same as for a
single needle (refer to page 21).
Slip one of the threads through the needle bar thread
guide on the left, and the other one on the right.
Thread the needles from front to back.
NOTE:
The needle threader cannot be used with the twin
needle.
q
MODE 1
MODE 2
CAUTION:
Turn the power switch off or press the lockout key
before changing the needle.
Do not use twin needles other than one included in
the standard accessories, otherwise the needle may
hit the needle plate, foot or hook and break.
q Lockout key
To Next Page
Loading...
