ELNA eXcellence 710 - Troubleshooting

88
Troubleshooting
Problem Cause Reference
The needle thread
breaks
1. The needle thread is not threaded properly.
2. The needle thread tension is too tight.
3. The needle is bent or blunt.
4. The needle is incorrectly inserted.
5. The needle thread is not set under the presser foot when start sewing.
6. The fabric is moved too fast when stitching free motion quilting.
7. The thread is tangled around the spool.
Page 21
Page 12
Page 17
Page 17
Page 29
Page 67
Use the spool holder.
The bobbin thread
breaks
1. The bobbin thread is not threaded properly in the bobbin holder.
2. Lint has collected in the bobbin holder.
3. The bobbin is damaged and does not turn smoothly.
Page 20
Page 85
Change the bobbin.
The needle
breaks
1. The needle is incorrectly inserted.
2. The needle clamp screw is loose.
3. The fabric is pulled forward when using the open-toe foot.
4. The needle is too ne for the fabric being used.
5. An inappropriate presser foot is used.
Page 17
Page 17
Page 67
Page 17
Use the correct foot.
Skipped stitches 1. The needle is incorrectly inserted, bent or blunt.
2. The needle and/or threads are not suitable for the work being sewn.
3. A blue tip needle is not being used for sewing stretch, very ne fabrics
and synthetics.
4. The needle thread is not threaded properly.
5. A poor quality needle is used.
Page 17
Page 17
Use the stretch stitch needle.
Page 21
Change the needle.
Version 1.00
21/04/2022
Audible Signal The Buzzer sounds when:
pip Normal operation.
pip-pip-pip Invalid operation or malfunction.
peep E1-E7 error occurred.
pip pi-pi-pi-peep Buttonhole is completed.
Warning Sign Cause Try this
The selected stitch patter cannot be ipped. Select the other stitch
pattern for a mirror image.
(E1-E7) The machine does not work properly due to a problem in
the control circuit.
Contact the service center
or the store from whom the
machine was purchased.