ELRO EL430DVR - Page 29

Page 29
Encoding
Settings
Set parameters of main code and sub-code streaming for
each channel: Encoding mode, Resolution, FPS, Stream
control, Image definition type, Stream value, I-frame interval,
and Video/Audio enabling
Network
Settings
Set basic network parameters, parameters of DHCP and
DNS, High-speed network download
Network
Service
PPPOE, NTP, Email, IP access rights, DDNS, mobile phone
monitoring, FTP, wireless call in, UPNP, simple DDNS
Output Mode
Name channels, set up preview prompt status, transparency,
area coverage, time and channel titles overlay
PTZ Settings
Set up channels, PTZ protocol, address, baud rate, data bits,
stop bits, parity
Serial Port
Settings
Set serial port functions, baud rate, data bits, stop bits, parity
Auto
Sequence
Settings
Set auto sequence mode and intervals
Management
Tools
Hard Drive
Management
Set specified hard drive as read/write disk, read-only disk,
redundant drive, data deletion, data recovery.
User
Management
Change user and user group. Change password. Add user
and user group. Delete user and user group
Online User
Force disconnection of a user logged into the network.
Disconnect and freeze the account until next reboot.
TV Tuning
Adjust upper/lower and left/right side margins of the TV
Auto
Maintenance
Set up system auto reboot, auto file deletion
Restore
Default
Reset setting status: General settings, encodings, recording,
alarm, network, network services, preview playback, serial
port, and user account management