Static Transfer Switch
STS207
User Manual
Page 2 (28)
ELTEK VALERE DEUTSCHLAND ©2009 UM_STS207_WEB_E_R1.4
Notes on this manual
ATTENTION! Read this manual carefully before installing and commissioning the specified module. This
manual is a part of the delivered module. Familiarity with the contents of this manual is required for
installing and operating the specified module.
The function description in this manual corresponds to the stage of technology at the date of publish-
ing. Technical changes and changes in form and content can be made at any time by the manufacturer
without notice. There are no obligations to update the manual continually. The rules for prevention of
accidents for the specific country and the general safety rules in
accordance with IEC 364 must be observed.
The module is manufactured in accordance with applicable DIN and VDE standards such as VDE 0106
(part 100) and VDE 0100 (part 410). The CE marking on the module confirms compliance with EU stan-
dards 2006-95-EG (low voltage) and 2004-108-EG (electromagnetic compatibility) if the installation and
operation instructions are followed.
Supplier:
ELTEK VALERE DEUTSCHLAND GmbH
GB Industrial
Schillerstraße 16
D-32052 Herford
+ 49 (0) 5221 1708-210
FAX + 49 (0) 5221 1708-222
Email Info.industrial@eltekvalere.com
Internet http://www.eltekvalere.com
Changes and errors excepted.
2009. ELTEK VALERE DEUTSCHLAND GmbH. All rights reserved.
Please note: No part of this document may be reproduced or transmitted in any form or by any means
-electronic or mechanical, including photocopying and recording- for whatever reason without the ex-
plicit written permission of Eltek Valere.
To Next Page
Loading...
Need help?
General