Eltek MultiCharger 1500

To Next Page

To Previous Page

Service menu

2280073 Rev.1 Page 35

Structure of service menu

Error log

Display error log?

Num. errors = x

Clear error log?

Error 9:

xxxxxx

Error 8…1:

xxxxxx

Error 0:

xxxxxx

Error log cleared

Exit menu

Factory settings

Load factory

settings?

Factory settings

loaded

Select Language

Sprache aktuell

Deutsch

Current language

English

Langue active

Francais

Taal actueel

Nederlands

Lingua corrente

Italiano

Idioma actual

Espanol

Save entries

Exit menu

Software version

MC1xDxx

Valittu kieli

Suomi

Main Page

Table of Contents3
Use6
Competent Person6
Normal Use6
Misuse6
Fundamental Safety Instructions7
Safety Symbols Used7
General Safety Instructions8
Construction of the Charger Unit13
General Mode of Operation13
Connections14
9-Pole SUB-D Socket15
Displays and Operating Controls16
Control Button 1 (On/Off)16
Control Button 2 (Start/Stop)16
Control Button 3 (Enter)16
Control Button 4 (Up)16
Control Button 5 (Down)16
USB Interface17
LED, Green, Yellow, Red17
LC Display17
Setting of Cable (Wire) Resistance18
Standard Battery-Connecting Cables18
Calculation of Cable Resistance18
Charging Process19
Positioning of the Multicharger19
Battery Preparation19
Charging of a Battery Installed in the Vehicle19
Charging of a Battery Outside the Vehicle20
Operating Modes/Charging Mode (Permanent Settings)21
Setting of Operating Modes21
Charging Mode for Lead-Acid Batteries (Charging Pb)21
Charging AGM Batteries22
Charging Gel Batteries22
Charging Motorcycle Batteries22
Charging Mode for 12V Lithium-Ion Batteries (Charging LIO)23
Overview of Applicable Voltage Ranges23
Output Voltage in Battery Charging Mode24
Output Current in Battery Charging Mode24
EPS Mode25
EPS Autostart Mode25
Operating Modes (Temporary Settings)26
Setting of Operating Modes26
Charging Mode for Lithium-Ion Batteries, Temporary26
Charging Mode for Lead-Acid Batteries, Temporary26
Refresh (if Disconnecting Switch of the Lithium-Ion Battery Is Open)27
Shutdown (Only Possible in the Charging Mode for Lithium-Ion Batteries)27
Internal Monitoring28
Mains Power Monitoring28
Monitoring of Intermediate-Circuit Voltage28
Output Overvoltage28
Output Undervoltage28
Output Overcurrent29
Temperature Monitoring29
Relay Monitoring29
External Monitoring30
Short Circuit30
Reverse Polarity30
Faulty Battery30
Clamp Contact30
Return Voltage30
Return Voltage with Reversed Polarity31
Shutdown Error31
Refresh Error31
Service Menu32
Setting of Operating Modes36
Charging Pb36
Charging LIO36
EPS 12V Mode36
EPS 24V Mode36
EPS Autostart Mode (Auto. Start EPS)36
Activate 24V Mode37
Mode On/Off37
Set Voltage37
Set 12V Pb Trickle Voltage37
Set 12V LIO Trickle Voltage37
Set 24V Trickle Voltage37
Set 12V Pb Charging Voltage38
Set 12V LIO Charging Voltage38
Set 24V Charging Voltage38
Set U-Shutdown38
Set U-Refresh38
Set 12V EPS Voltage38
Set 24V EPS Voltage38
Set Voltage Limits39
Set Ua Max. 12V39
Set Ua Min. 12V39
Set Ua Max. 24V39
Set Ua Min. 24V39
Output-Current Limits (I-Limits)40
Set I-Limit CHRG12V40
Set I-Limit CHRG24V40
Set I-Limit EPS 12V40
Set I-Limit EPS 24V40
Set Process Times41
Set Switch Back Time41
Set Maximum Charging Time41
Set I-Limit41
Set Cable (Wire) Resistance41
Turn On/Off Autostart42
Autostart Now Enabled and Autostart Now Disabled42
Error Log42
Error42
Derating43
Factory (Default) Settings44
Select Language44
Technical Data45
Appendix A Status and Error Descriptions47

Eltek MultiCharger 1500 - Page 35

Table of Contents