2280073 Rev.1 Page 3
Contents
Page
Use 6
1.1 Competent person 6
1.2 Normal use 6
1.3 Misuse 6
Fundamental safety instructions 7
2.1 Safety symbols used 7
2.2 General safety instructions 8
Construction of the charger unit 13
3.1 General mode of operation 13
3.2 Connections 14
3.2.1 9-pole SUB-D socket 15
3.2.2 15-pole SUB-D socket 15
3.3 Displays and operating controls 16
3.3.1 Control button 1 (on/off) 16
3.3.2 Control button 2 (start/stop) 16
3.3.3 Control button 3 (enter) 16
3.3.4 Control button 4 (up) 16
3.3.5 Control button 5 (down) 16
3.3.6 USB interface 17
3.3.7 LED, green, yellow, red 17
3.3.8 LC Display 17
Setting of cable (wire) resistance 18
4.1 Standard battery-connecting cables 18
4.2 Calculation of cable resistance 18
Charging process 19
5.1 Positioning of the MultiCharger 19
5.2 Battery preparation 19
5.3 Charging of a battery installed in the vehicle 19
5.4 Charging of a battery outside the vehicle 20
Operating modes/charging mode (permanent settings) 21
6.1 Setting of operating modes 21
6.2 Charging mode for lead-acid batteries (Charging Pb) 21
6.3 Charging AGM batteries 22
6.4 Charging gel batteries 22
6.5 Charging motorcycle batteries 22
6.6 Charging mode for 12 V lithium-ion batteries (Charging LIO) 23
6.7 Overview of applicable voltage ranges 23
6.7.1 Output voltage in battery charging mode 24
6.7.2 Output current in battery charging mode 24
6.8 EPS mode 25
6.9 EPS autostart mode 25
To Next Page
Loading...