2280073 Rev.1 Page 4
Page
Operating modes (temporary settings) 26
7.1 Setting of operating modes 26
7.2 Charging mode for lithium-ion batteries, temporary 26
7.3 Charging mode for lead-acid batteries, temporary 26
7.4 Refresh (if disconnecting switch of the lithium-ion battery is open) 27
7.5 Shutdown (only possible in the charging mode for lithium-ion batteries) 27
Internal monitoring 28
8.1 Mains power monitoring 28
8.2 Monitoring of intermediate-circuit voltage 28
8.3 Output overvoltage 28
8.4 Output undervoltage 28
8.5 Output overcurrent 29
8.6 Temperature monitoring 29
8.7 Relay monitoring 29
External monitoring 30
9.1 Short circuit 30
9.2 Reverse polarity 30
9.3 Faulty battery 30
9.4 Clamp contact 30
9.5 Return voltage 30
9.6 Return voltage with reversed polarity 31
9.7 Shutdown error 31
9.8 Refresh error 31
Service menu 32
10.1 Setting of operating modes 36
10.1.1 Charging Pb 36
10.1.2 Charging LIO 36
10.1.3 EPS 12V mode 36
10.1.4 EPS 24V mode 36
10.1.5 EPS autostart mode (Auto. start EPS) 36
10.2 Activate 24V mode 37
10.2.1 24V mode on/off 37
10.3 Set voltage 37
10.3.1 Set 12V Pb trickle voltage 37
10.3.2 Set 12V LIO trickle voltage 37
10.3.3 Set 24V trickle voltage 37
10.3.4 Set 12V Pb charging voltage 38
10.3.5 Set 12V LIO charging voltage 38
10.3.6 Set 24V charging voltage 38
10.3.7 Set U-Shutdown 38
10.3.8 Set U-Refresh 38
10.3.9 Set 12V EPS voltage 38
10.3.10 Set 24V EPS voltage 38
To Next Page
Loading...