ELTEX NTU-52V - Page 38

 NTU-52V/VC. User manual (user)
38
•
•
•
•
•
•
•
AdvManagedFlag –enable/disable 'Managed' flag sending in RA;
AdvOtherFlag –enable/disable Other RA flag sending.
To save the changes, click the 'Apply Changes' button.
5.4.6.2 The 'DHCPv6 setting' submenu. DHCPv6 server configuration
This submenu is used to configure DHCPv6 server. By default, it operates in auto configuration mode
(DHCPServer(Auto)) via prefix delegation.
Advance → IPv6 → DHCPv6
DHCPv6 Mode–select mode:
NONE–operation without DHCP server;
DHCPRelay–DHCP repeater operation mode;
DHCPServer (Manual)–manual configuration of DHCP server;
DHCPServer(Auto)–DHCP server auto-provisioning.
To save the changes, click the 'Apply Changes' button. After clicking on the 'Show Client' button, a table of
active DHCPv6 server IP addresses will be displayed.
Advance → IPv6 → DHCPv6→ Show Client
5.4.6.3 The 'MLD proxy' submenu. MLD proxy function configuration
In this section you can enable/disable MLD-proxy operation. For this you should check 'Enable/Disable'.
Advance → IPv6 → MLD proxy
To save the changes, click the 'Apply Changes' button.