ELTEX NTU-RG-5402G-W - Indication of LAN Interfaces; Reboot;Reset to Factory Defaults; Delivery Package

 NTU-RG-54xx Operational manual
17
2.7 Indication of LAN Interfaces
Table 6 lists operation modes shown by LAN ports LEDs located on the rear panel of the device.
Table 6 – Light Indication of LAN Interfaces
Operation Modes Yellow LED Green LED
Port is in 1000Base-T mode, no data transfer solid on off
The port is in the 1000Base-T mode, data
transfer
flashes off
Port is in 10/100Base-TX mode, no data transfer off solid on
The port is in the 10/100Base-TX mode, data
transfer
off flashes
2.8 Reboot/Reset to factory defaults
For device reboot, press the "Reset" button once on the device side panel. In order to reset the device to the
factory settings, press the "Reset" button and hold it for 7-10 seconds until the indicator glows red and all
other LEDs go out. Factory settings for IP address are:LAN–192.168.1.1, subnet mask –
255.255.255.0.Access can be provided from LAN 1, LAN 2, LAN 3 and LAN 4 ports.
2.9 Delivery Package
NTU-RG standard delivery package includes:
• NTU-RG optical network terminal;
• 220V/12V power adapter;
• Operation manual.